RRC 1258 Support in English > General discussion forum

NANO APP ANDROID FOR KENWOOD

<< < (2/2)

dj0qn:
I meant that you had the wrong settings in the app. If the radios talk to each other fine,
the problem is probably not with the RRC. However, make sure you are using the newest
firmware in the RRC's that support Nano.

73,
Mitch DJ0QN / K7DX

oz1rh:
I and others have similar problems with Nano Icom and Nano Elecraft, see
http://www.remoterig.com/forum/index.php?topic=4982.msg23562#msg23562
http://www.remoterig.com/forum/index.php?topic=5020.msg26186#msg26186

Quite often my Nano apps shows the valid licence red and then after some time the app ends with 'stopped working'. After restarting the app the licence code is green as it should be.

It seems the Remoterig folks pay no attention to these old problems with the Nano apps.

My Icom remote site works with my IC-7100 control panel and the Elecraft site works with my K3/0 Mini.

73, Palle, OZ1RH.

LA4ESA:
Thanks for new reply.
Have tried several different settings in app, due to jitter buffer size and jitter delay. The ports are the same as in RRC.
Have also updated RRC to the latest firmware.
Band switch still out of function.
But i can change band via the freq setting. I can sett the frew manually and than turn the VFO.
Than put in a new freq on another band and again turn the VFO.
It's ok in this way. not going to spend too much time trying to figure this out.
This will never be the main way to run the raido remotely.
But, it is very comfortable to have the possibillity.
Thanks for your cooperation.  :D

73 de Per LA4ESA

partytyme:
no support  this sucks i gave up 

dj0qn:
What exactly is your problem? Maybe if you were to clearly describe it,
someone may be able to help you.

Navigation

[0] Message Index

[*] Previous page