RRC 1258 Support in English > Configuration, RRC 1258
Can not connect-device manager shows no virtual ports installed
KZ5D:
I cannot connect the K3/0 to remote K-3 over my LAN. Device manager shows NO serial ports installed. Both RRC units have been setup correctly and are showing connectivity to the router.
dj0qn:
You must first install the Microbit Setup Manager to get the drivers installed.
However, the connection to the remote has nothing to do with virtual serial ports. It uses SIP
over the network.
73,
Mitch DJ0QN / K7DX
KZ5D:
Mitch, as always, you are a brilliant resource. The issue has been corrected. I used the router's IP at first. Once I entered the correct IP in the SIP, connected as expected. Thank you so much!
73,
Art KZ5D
dj0qn:
Glad to hear it, Art.
73,
Mitch DJ0QN / K7DX
K5OA:
I am having a problem after a few years without a hitch. I can see four Com ports set up by the 1258 as 4-5-6-7 and always port com 4 was the main one I used to interface to N1mm and HRD and Win4K3 etc. but not they like com 5 and there is no ComExtra for Rtty. I have redone many times now with any help. I have a Winkey using Com3 and did not change. This is on the K3 Mini end.
I have gone back to ASFK for now but it anyone has an answer for the missing ComExtra It was com2 once as I can see that in my N1MM config for Digi mode. On the Radio end it is Com 10 and working fine if local at site.
The Microbit does not show the 45RTTY as a section point in the I/O section like I see notes on from others. Running version 007 firmware 2.86 Like this since 2015-05-28 was uploaded to 1258
Thanks one and all! Happy Holidays
Navigation
[0] Message Index
[#] Next page
Go to full version