RRC 1258 Support in English > General discussion forum
Vox with Icom IC-7100
(1/1)
W7HLR:
Vox does not work when the IC-7100 is in the remote control configuration, but is fine when directly connected to the base rig. Is Vox supported via remote? Is so, how do I configure?
dj0qn:
To allow VOX to work with any rig under RemoteRig, you must change under advanced settings
the "RTP tx mode" to "continuous" on both RRC's.
73,
Mitch DJ0QN / K7DX
W7HLR:
Thank you, Mitch! Works fine now.
Navigation
[0] Message Index
Go to full version