RRC 1258 Support in English > Configuration of Routers, Firewalls, etc

RRC issue with 857/WiFi

<< < (2/2)

dj0qn:
Good luck. These sort of things are figured out by the process of elimination, so at least you
can narrow down where the problem lies.

73,
Mitch DJ0QN / K7DX

vk7hh:
Thanks for the reply.

So I did some further testing tonight. I can get the Control RRC to connect via the TPLink in client mode to my phone which is in hotspot mode. Aside from the occasional dropped packet (can probably change this in settings) it seems to be working and fires up everytime.

I then tried on two different wifi access points at  home here and they will not connect properly. I did on one occasion get the remote rig to connect. It clicked as if powering on once, then the second time it tried again and connected. I then switched the rig off, reconnected and it clicked three times to try and power up, but doesn't.

I've checked all my IP settings, and I can ping from my laptop the remote end, and access the internet fine. I even went into hotspot mode in the TPLink and disabled SIP ALG.

Also tried the TPLink in a hotspot mode, but still no go. The Control RRC works fine on my home network, so it's not an issue with my core router.

Maybe it's just a rubbish TPLink device...

SM5DXU:

--- Quote from: vk7hh on 2018-01-22, 11:45:58 ---Thanks for the reply.

So I did some further testing tonight. I can get the Control RRC to connect via the TPLink in client mode to my phone which is in hotspot mode. Aside from the occasional dropped packet (can probably change this in settings) it seems to be working and fires up everytime.

I then tried on two different wifi access points at  home here and they will not connect properly. I did on one occasion get the remote rig to connect. It clicked as if powering on once, then the second time it tried again and connected. I then switched the rig off, reconnected and it clicked three times to try and power up, but doesn't.

I've checked all my IP settings, and I can ping from my laptop the remote end, and access the internet fine. I even went into hotspot mode in the TPLink and disabled SIP ALG.

Also tried the TPLink in a hotspot mode, but still no go. The Control RRC works fine on my home network, so it's not an issue with my core router.

Maybe it's just a rubbish TPLink device...

--- End quote ---
You may be right. I replaced the TPLink router supplied by the internet provider for the remote QTH with a D-Link router and the remote control started working right away!

The internet provider has since then changed their choice to D-Link!

Skickat från min F5121 via Tapatalk

Navigation

[0] Message Index

[*] Previous page

Go to full version