RRC-Micro PC Client in English > General discussion

Elecraft K3/0 mini, PTT and MH-2 mic

<< < (2/2)

dj0qn:
No, the RRC does not block PTT or the microphone audio. Again, this is done in hardware and
not in the RRC firmware.

Did you change the microphone input on the K3 to the rear input? Maybe you left it on the
front input. You need to do this using the menu or the quick menu buttons.

73,
Mitch DJ0QN / K7DX

la7pka:
Hi.
Yesterday I disconnected the K3 and the K3/0-mini-F from the RR boxes. Configured the K3 to have the rP.H and the K3 Mini to fP.H.
Then I connected both units back to the RR boxes.
The PTT from the MH-2 did not work. Audio was muted when MIC PTT was pushed.
I pushed VOX also, to test and the RX immediately responded, and also Audio.
Both RR boxes are connected via LAN.
The K3/0-MINI-F is using the RRMINICBL. Could this be causing some issues ?
I have configured both RR boxes as K3 Twin.
The mini I received before yearend from Elecraft, the RR  boxes I got August/September 2017.
Is there any need for upgrading the K3 remote head ?
I have upgraded the K3 and the two RR boxes to the latest firmware.

Vidar

dj0qn:
Please contact Elecraft support. They provide the support for the K3/0 Mini.

73,
Mitch DJ0QN / K7DX

oz1rh:
You wrote: Configured the K3 to have the rP.H and the K3 Mini to fP.H.
There is no config in the K3/0 Mini (other than firmware). What ever config you do from the panel of the K3/0 Mini while connected will be config of the K3. If you have configured fP.H while connected this is the error. From the control site you must configure K3 for rP.H pressing Config on the K3/0 Mini while connected.

73, Palle, OZ1RH.
www.oz1rh.com

Navigation

[0] Message Index

[*] Previous page