RRC 1258 Support in English > Configuration, RRC 1258
USB with CAT on Radio Unit side
dj0qn:
The CAT would be included as part of the stream that goes over the network with SIP audio, etc.
It does not affect anything else, which will continue to run as before. It will just add a tiny bit of
overhead roughly equal to the baud rate that you set.
If you install CAT per my first instructions, you can use it on the control side. If you want to use CAT
on both the control and radio side in parallel, just change the radio COM1 setting to mode-6 or mode-7
and use COM1 for CAT control (set "use USB Com Port as COM2" to "Yes" to use USB).
Again, I have never used the 857, so I am assuming these settings are roughly the same as for the
TS-480.
73,
Mitch DJ0QN / K7DX
Navigation
[0] Message Index
[*] Previous page
Go to full version