RRC-Nano > General

TS2000 with Nano, no power on

(1/3) > >>

m0pai:
Searched but couldn't find any answer, sorry if already been discussed..

I've successfully got my new RRC-1258's working with the TS2000 and Remote head, made a couple of contacts while away from home  8)

I now want to get the NANO working but I've run into an issue with what could be down to my settings.

1.Radio doesn't switch on via app (turns off ok) but I have audio through the phone if I manually switch on.
2. Buttons on app are not functional and no frequency display.

I have the straight com cable connected from radio to RRC

COM2 mode 4
 COM2 baudrate 4800 (set same in radio)
 COM2 data bits 8
 COM2 stop bits 1
 COM2 parity 0-off
 COM2 terminator (hex) 00

Samsung S6 edge (4g network) with NANO 1.5.1
Sip port 1300 (same RRC)
UDP AUDIO 13001 (same rrc)
" " CMD 13002 (same as rrc)
COM 2
Jitter 4
Delay 3

Sip contact I took from rrc (few letters & number)########.ddns.remoterig.com

During initial installation of RRC, jumper 3 wasn't touched and remains default  (strapped)

Could it just be my phone not being good with the app or have I missed something obvious?

Thanks
Adrian

dj0qn:
Adrian,

I am not 100% sure, but just a guess: change the program mode in the radio RRC  from 8 to 4 and see if that
solves your problem. Hope fully you have access to your radio RRC remotely.

73,
Mitch DJ0QN / K7DX

m0pai:
Thanks for the reply Mitch,

Tried changing to the radio setting 8 to 4 in the radio RRC but no change.

I can still get audio, TX, band change and direct frequency input when I manually switch the radio on.

The dial changes the radio frequency on the odd occasion but doesn't relay the change to the app (no frequency display)

Radio still switches off via the app.

The buttons and tuning dial in the app are only functional if I come off the app and open it back up again.

Hopefully I can find a solution as it would be a great addition to my Remoterig setup.

73
Adrian

dj0qn:
Adrian,

The Nano app also requires a working CAT. Do you have the serial cable installed between the TS-2000 and the
RRC COM2 port? I assumed that you did, but maybe you don't use a computer for logging or control.

73,
Mitch DJ0QN / K7DX

m0pai:
Hi Mitch,

Yes the cable is installed between the Ts2000 and RRC, settings for Com2 :COM2 mode 4
 COM2 baudrate 4800 (set same in radio)
 COM2 data bits 8
 COM2 stop bits 1
 COM2 parity 0-off
 COM2 terminator (hex) 00

I used to use the radio with the serial cable for CAT control before I purchased the RRC so I can confirm the cable works ok.

I haven't tried connecting the remote RRC to the com port for logging ect as yet.

73 

Navigation

[0] Message Index

[#] Next page