RRC 1258 Support in English > Hardware, Cabling, Installations

Running station accessories using the COM Ports

(1/1)

wb7ely:
I have a requirement to turn on a fan at the radio side and to switch a coax relay. I see that the COM Port out0 goes low upon connection. Could I use a relay driver connected to out0 to turn on a small fan? Would it be possible to set a logic 1 on other comport pins to toggle a relay?

wb7ely:
Looks like Amazon sells a 4 channel RS232 relay board that would connect to the radio side RRC COM1 port. Here's a link: https://www.amazon.com/SainSmart-2-Channel-Serial-Control-4-Channel/dp/B01G160I5S
You could turn on a fan in the radio box or actuate a coax relay on command using this sweet little board.
Instructions say to first set the serial port configuration to 9600 baud: stty -F /dev/ttyM0 9600
Turn on the relay with hex 01 : echo -ne '\x01' >/dev/ttyM0
Turn off the relay with hex 00 : echo -ne '\x00' >/dev/ttyM0

Navigation

[0] Message Index