RRC 1258 Support in English > General discussion forum
COM 0
py2xb:
Guys hello
I am preparing my remote station. I would like to have an input on this:
Remoterig has 4 COM ports (COM0, COM1, COM2 and Virtual only COM3). Please validate this:
1) COM0 physically is the TTL port on the interfaces. I use TS480 with detachable head and in this case it is used for communication between the head (panel) and the radio
2) If the about is true, how can I use RTS or DTS of COM0 (which is not physically available in COM0/TTL connector) ?
++Remoterig manual extract attached (page 76)
Many thanks Fred PY2XB
sm2o:
it's only com1 which have a status signal in each direction, the other only have RXD and TXD
There are many other comport over internet devices available if you need full comports
73 de mike
py2xb:
Mike thanks. I understand fully the use of COM ports. I am trying to use most of the Remoterig bulit in ports and I/Os before evaluating how many ports of additional serial server devices I need.
My point here is that the manual states how to use RTS and DTR COM 0 signals for PTT and CW, but the signals (RTS/DTR) do not physically exist in the Radio RRC.
Either I am not understanding well COM 0 usage or the manual is incorrect. I am trying to get some light on this.
Best regards and thanks again Fred
sm2o:
They are available when using USB for com0 but you can't do that when unsing TS-480
/mike
py2xb:
Mike tks again. I supposed this was the case. However, if I am using a radio controlled by CAT (COM0 free) the physical RTS/DTR COM 0 signals exist to the user at Radio RRC?
Perhaps they may be directly (internally) connected to PTT/CWkeyer circuitry at the Radio RRC, without been exposed to the user. Is it Correct ?
Thanks Fred
Navigation
[0] Message Index
[#] Next page
Go to full version