RRC 1258 Support in English > General discussion forum
Expert 2K-FA remote control via its serial Port
(1/1)
py2xb:
Hi Guys
I want to remote control the 2K-FA amplifier using its serial port. I am using Remoterig COM1 for this matter ( it could it COM2 too)
However the amplifier's serial port has a FIXED speed of 115Kbps (cant be changed, per manual). Remoterig does not allow to set this speed (max is 64K).
Is any of you using Remoterig ports to control the 2K-FA?
Thanks input
Fred
dj0qn:
Hi Fred,
This has been covered on the Forum before if you search it.
You need a different version of the client that has been available for years, but may still not be on the SPE site. I can send it to you if you need it via email.
73,
Mitch DJ0QN / K7DX
Gesendet von meinem SM-G955U mit Tapatalk
py2xb:
Hi Mitch
Per your answer it seems that in old client version the speed can be changed. However, I have understood from Manual that the firmware of the 2k-Fa fixes the serial speed to 115Kbps, regardless if the client has the ability to change speed.
Anyway, yes, I would appreciate if you could send me the old client version. Regards and thanks again Fred
sm2o:
There are instructions about this topic on the website
http://www.remoterig.com/wp/?page_id=426
73 de mike
Navigation
[0] Message Index
Go to full version