Author Topic: Expert 2K-FA remote control via its serial Port  (Read 2675 times)

py2xb

  • Jr. Member
  • **
  • Posts: 34
    • View Profile
    • Email
Expert 2K-FA remote control via its serial Port
« on: 2018-06-06, 18:08:35 »
Hi Guys
I want to remote control the 2K-FA amplifier using  its serial port. I am using Remoterig COM1 for this matter ( it could it  COM2 too)

However the amplifier's serial port has a FIXED speed of 115Kbps (cant be changed, per manual). Remoterig does not allow to set this speed (max is 64K).

Is any of you using Remoterig ports to control the 2K-FA?

Thanks input

Fred

dj0qn

  • Hero Member
  • *****
  • Posts: 2223
    • View Profile
    • DJ0QN / K7DX
    • Email
Re: Expert 2K-FA remote control via its serial Port
« Reply #1 on: 2018-06-06, 18:38:02 »
Hi Fred,

This has been covered on the Forum before if you search it.

You need a different version of the client that has been available for years, but may still not be on the SPE site. I can send it to you if you need it via email.

73,
Mitch DJ0QN / K7DX

Gesendet von meinem SM-G955U mit Tapatalk


py2xb

  • Jr. Member
  • **
  • Posts: 34
    • View Profile
    • Email
Re: Expert 2K-FA remote control via its serial Port
« Reply #2 on: 2018-06-06, 18:51:09 »
Hi Mitch

Per your answer it seems that in old client version the speed can be changed. However, I have understood from Manual that the firmware of the 2k-Fa fixes the serial speed to 115Kbps, regardless if the client has the ability to change speed.

Anyway, yes, I would appreciate if you could send me the old client version. Regards and thanks again  Fred

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3004
    • View Profile
    • sm2oan
    • Email
Re: Expert 2K-FA remote control via its serial Port
« Reply #3 on: 2018-06-06, 19:43:30 »
There are instructions about this topic on the website

http://www.remoterig.com/wp/?page_id=426

73 de mike