RRC 1258 Support in English > General discussion forum
IC7100 issue
iz0tws:
Hi I have a problem,
working for two years without problem.
Same connection, modem, firewall ports are open and checked.
Rebooted everything.
When I switch on the consolle of IC7100 the yellow light on the aux/mic cable blink one time (couple of seconds) without switching on the radio.
from the telnet of both the side I have these messages...
Debug from RRC
duplex: New Audiocoding 104 (12 KHz)
duplex: New Audiocoding 104 (12 KHz)
New UDP CmdTxPort=13002
duplex: New Audiocoding 104 (12 KHz)
duplex: New Audiocoding 104 (12 KHz)
New UDP CmdTxPort=13002
R-> Radio ON requested (2)
rtp enable [82.55.45.184/13001 82.55.45.184/13001]
R-> Connection established, radio ON, audioQuality=4
duplex: New Audiocoding 104 (12 KHz)
New radioctrlTxPort: 1031
R-> Sending '8V is off'
R-> Radio '8V off' from panel
rtp disable
Debug from CP
CP-> Radio ON(Idle)
duplex: New Audiocoding 102 (8 KHz)
duplex: New Audiocoding 102 (8 KHz)
duplex: New Audiocoding 102 (8 KHz)
New UDP CmdTxPort=13002
rtp enable [79.56.236.137/13001 79.56.236.137/13001]
CP-> Sending 8V: 0 Mute spk: 0
CP-> audioQuality=2
duplex: New Audiocoding 102 (8 KHz)
CP-> Panel '8V off' from radio
CP-> Radio/Panel OFF (0)
rtp disable
duplex: New Audiocoding 102 (8 KHz)
the rtp disable message it is returned after couple of seconds
How can I solve this issue? which is the cause?
sm2o:
Hi
what does the status page in each unit says ?
73 de mike
iz0tws:
CP
Name Value
P5.4 OFF
Radio OFF
Connection status Disconnected
SIP status Idle
Last SIP error None
RTP/UDP audio status Disconnected
UDP cmd status Disconnected
SIP command timeout 0
Rx Jitter buffer size 4
Rx Jitter delay 3
Dual Rx 0
SIP Out port 13000
SIP In port 13000
Audio Out port 13001
Audio In port 13001
Command Out port 13002
Command In port 13002
External SIP In port 13000
External Audio In port 13001
External Cmd In port 13002
Other party xx.56.236.137
Other party(mac) 00:1e:fd:01:98:15
Input 0 High
Input 1 High
Input 2 High
Output 0 Low
Output 1 Low
Output 2 Low
DNS status OK, xxxxx.strangled.net = xx.56.236.137
Active profile Ciampino
PTT status OFF
Common network settings No
System messages No
RRC
P5.2 OFF
Connection status Disconnected
SIP status Idle
Last SIP error None
RTP/UDP audio status Disconnected
UDP cmd status Disconnected
SIP command timeout 0
Rx Jitter buffer size 4
Rx Jitter delay 3
Dual Rx 0
External IP xx.56.236.137
SIP Out port 13000
SIP In port 13000
Audio Out port 1024
Audio In port 13001
Command Out port 1024
Command In port 13002
External SIP In port 13000
External Audio In port 13001
External Cmd In port 13002
Other party xx.7.187.25
Other party(mac) 00:1e:fd:01:9e:e5
Input 1 High
Input 2 High
Output 0 Low
Output 1 Low
Output 2 Low
Dynamic DNS status OK
Ping status (watchdog) OK [0 ms]
DNS status OK, remoterig.com = 213.180.92.125
Active profile Default
PTT status OFF
Antenna-Switch (IP) not connected
Common network settings No
System messages No
iz0tws:
any brilliant idea?
iz0tws:
maybe can help
(I tried with the radio off and I have the same exact message, so it seems depending form remoterig device itself)
debug level 2 (+)
REMOTE
duplex: New Audiocoding 109 (24 KHz)
duplex: New Audiocoding 109 (24 KHz)
New UDP CmdTxPort=13002
SIP Saved Call-ID '19011186@192.168.1.30'(2)
duplex: New Audiocoding 109 (24 KHz)
duplex: New Audiocoding 109 (24 KHz)
duplex: New Audiocoding 109 (24 KHz)
New UDP CmdTxPort=13002
SIP Saved Call-ID '19011186@192.168.1.30'(2)
R-> Radio ON requested (2)
rtp enable [79.49.230.215/13001 79.49.230.215/13001]
R-> Connection established, radio ON, audioQuality=9
duplex: New Audiocoding 109 (24 KHz)
queueExtIOManually, In1=8 In2=32 In0=4
sendExtInputs, In1=8 In2=32 In0=4
New radioctrlTxPort: 1124
controlUDPMsg, Out1=255 Out2=255 Out0=4
New rcpTxPort: 1124
>>>Unknown ICMP-package received, type 56 code 1
>>>Unknown ICMP-package received, type 56 code 1
Got Radio Info, Len 5, data: '8VOff'
R-> Radio '8V off' from panel
ptt off (delayed)
R-> Sending '8V is off'
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
ptt off (delayed)
rtp disable
>>>Unknown ICMP-package received, type 69 code 0
ptt off (delayed)
CP
duplex: New Audiocoding 109 (24 KHz)
duplex: New Audiocoding 109 (24 KHz)
New UDP CmdTxPort=13002
rtp enable [79.27.223.245/13001 79.27.223.245/13001]
queueExtIOManually, In1=8 In2=32 In0=4
sendExtInputs, In1=255 In2=255 In0=4
CP-> Sending 8V: 0 Mute spk: 0
CP-> audioQuality=9
duplex: New Audiocoding 109 (24 KHz)
Got Radio Info, Len 5, data: '8VOff'
CP-> Panel '8V off' from radio
CP-> Radio/Panel OFF (0)
rtp disable
duplex: New Audiocoding 109 (24 KHz)
Navigation
[0] Message Index
[#] Next page
Go to full version