RRC 1258 Support in English > General discussion forum

TS-480 hangs/ no audio after power on

(1/2) > >>

k5tri:
Hi,

About two days ago I encountered a weird issue. My Remote Rig setup was working perfectly fine and stable between my shack in Redmond, WA and my
remote station in Germany.
Now when I turn on the radio, I get full display but no RX audio. After a few seconds the controls then freeze and I can't even power off the radio using the
power button on the control head. A few seconds after the freeze, the radio powers off by itself.

I tried a hard reboot (a.k.a. power off) at both ends to no avail. No config changes have been made between the two states.

73 Mike K5TRI

dj0qn:
Hi Mike,

Did you reboot the routers? This problem is an internet issue and is usually caused by a router problem.

73,
Mitch DJ0QN / K7DX

k5tri:
I haven't touched anything, nothing changed, this behavior appeared out of the blue. It turned out to only appear on
USB/ LSB but not CW. I fiddled a bit with the input and output settings and for now it seems to work fine. I'll need to
stress test to ensure that fixed it.

73 Mike K5TRI

dj0qn:
I think you misunderstood me.

You should reboot both routers and the problem will likely go away.
It us caused by a buffer filling up in a router.

73,
Mitch DJ0QN / K7DX

k5tri:
Curious, which buffer are you referring to and which routers did you see this happen with?
Will try that but would like to understand more.

73 Mike

Navigation

[0] Message Index

[#] Next page