Author Topic: TS-480 I/O settings  (Read 3977 times)

LA1RSA

  • Newbie
  • *
  • Posts: 28
    • View Profile
    • Email
TS-480 I/O settings
« on: 2019-01-17, 14:59:22 »
Hei,
Anyone that has the right I/O settings for TS-480 SAT
All works fine except from CW keying, it only sends a long tone whatever I'm keying.

Thanks/ LA1RSA

dj0qn

  • Hero Member
  • *****
  • Posts: 2223
    • View Profile
    • DJ0QN / K7DX
    • Email
Re: TS-480 I/O settings
« Reply #1 on: 2019-01-17, 17:19:20 »
Here is my CW checklist for the TS-480:


CW Checklist
------------------------------
on the radio RRC:
- under keyer settings, set PTT activated by keyer to YES
- under I/O settings, change OUT2 mode to KEYER

on the control RRC:
- under keyer settings, set enable to YES
- change other keyer settings as desired
- under I/O settings, set IN0 mode to KEYER

Make sure that the cable is connected between the radio RRC and rig's key (NOT paddle) jack. If possible,
use a mono plug on the rig side, since stereo can cause problems under certain situations (e.g. FSK).

73,
Mitch DJ0QN / K7DX



LA1RSA

  • Newbie
  • *
  • Posts: 28
    • View Profile
    • Email
Re: TS-480 I/O settings
« Reply #2 on: 2019-01-17, 22:06:27 »
Hei Mitch,
Thanks so much for your help, it solved the problem :)

73`LA1RSA / Frank