RRC 1258 Support in English > General discussion forum
Noisy Low band generated from PoE of 1269 10 x antenna switch
(1/1)
iz8eyp:
Hello Everyone,
After installation of Remote Antenna Switch 1269 that is powered thought PoE at 48 Volts I noted that some noise appear on 160/80m but notable even on high bands as 10m.
Does Anyone had the some problem ? In case how you fixed.
I tried to insert in between a EMC filter but doesn't work. The only thing I haven't try is to use an external injector and use a linear 48 Volts DC PS.
I attached herein a pic of peaks to let you see.
NA6O:
If you can power it from a clean linear supply, that may completely solve your problem. In any case, a proper common-mode choke on the ethernet cable is mandatory. Use a 2.4 inch mix 31 toroid, Fair-Rite 2631803802. 14 turns neatly wound in a single layer. Place this right next to the POE injector. Expect at least 20 dB of noise reduction. A second one on the dc cable from the switching supply would further improve the noise reduction.
For complete information, see http://k9yc.com/RFI-Ham.pdf
Gary, NA6O
SM4KYN:
Hi,
Have you tried to put ethernet interface into 10MBit instead of auto.
I had the same problem on WEB-switch 1216H.
/Anders
Navigation
[0] Message Index
Go to full version