RRC 1258 Support in English > General discussion forum

Remote rig and HRD/Supercontrol, display issues

(1/1)

PA5M:
When I was testing my FT-857 with HRD and also with Supercontrol.
I found that the display reading in both programs is unstable.
Most of the time the reading was incorrect with a lot of "b7C#" bla bla.
The TX/RX function in Supercontrol was also tested at the same time and it worked without problems.

I changed the baudrate settings, etc, in both the interfaces and the programs, but without luck.
Good to mention that I was doing those tests on my internal (1GB) network, so no delays occurred.
Has anyone got ideas how to get a proper corresponding display ?

73e Michael
PA5M

Navigation

[0] Message Index