RRC 1258 Support in English > Configuration, RRC 1258

RRC COM PORTS AVAILABILITY

(1/1)

Pedro:
Hi,

I wonder if it's possible to use all the 3 ports available (com0, com1 and com2) as follows:

com0: CI-V control for ICOM tranceiver (through TTL or USB in control side);
com1: amplifier control;
com2: rotor control.

In the remoterig web page (http://www.remoterig.com/wp/?page_id=362) it seems to be possible to get this combination (Replacing traditional PC-Remote control), having the radio, amp and rotor remotely controlled.

In my setup I was able to get Radio and Amplifier fully controlled but not the rotor because com2 in the control side is attached "logical parallel with com0"... and I would like to use it for rotor control.

As far as I could read in other topics, TTL would permit radio CAT control (CI-V). So I wonder, if I use it, I would be able to use com2 for rotor control.

In this case a converter TTL - RS232 must be used...is there a scheme with wires connections available for this converter?

Thanks

Pedro
 


Navigation

[0] Message Index

Go to full version