Author Topic: ProSiStel no link  (Read 5407 times)

IZ7ANL

  • Jr. Member
  • **
  • Posts: 50
    • View Profile
    • Email
ProSiStel no link
« on: 2011-08-24, 00:49:21 »
Any link is avalable on page ProSistel Rotor. Any body can help me to configure and a picture to connect RS232.
My best regard
Nick 73

ON4AOI

  • Sr. Member
  • ****
  • Posts: 295
    • View Profile
    • Email
Re: ProSiStel no link
« Reply #1 on: 2011-08-24, 18:18:58 »
check one of my previous post with schematics

Guy ON4AOI

IZ7ANL

  • Jr. Member
  • **
  • Posts: 50
    • View Profile
    • Email
Re: ProSiStel no link
« Reply #2 on: 2011-08-25, 00:32:37 »
I didn't find anythings in old post. May you help me?
73 Nicola

ON4AOI

  • Sr. Member
  • ****
  • Posts: 295
    • View Profile
    • Email
Re: ProSiStel no link
« Reply #3 on: 2011-08-25, 06:22:06 »
Hi Nick if you do a search for prositel and on4aoi you find it easy

here is the link

http://www.remoterig.com/forum/index.php?action=dlattach;topic=391.0;attach=107;image

Guy ON4AOI

IZ7ANL

  • Jr. Member
  • **
  • Posts: 50
    • View Profile
    • Email
Re: ProSiStel no link
« Reply #4 on: 2011-08-25, 23:17:39 »
Many thanks Guy. May you tell me about the setting, serial mode 3 or 5?
73 Nicola

ON4AOI

  • Sr. Member
  • ****
  • Posts: 295
    • View Profile
    • Email
Re: ProSiStel no link
« Reply #5 on: 2011-08-26, 07:55:58 »
Hi Nicola

Mode should be 3
baud rate = 9600
data bits=8
stop bits=1
parity=0
Rts/cts = Yes

in both boxes

Guy ON4AOI

IZ7ANL

  • Jr. Member
  • **
  • Posts: 50
    • View Profile
    • Email
Re: ProSiStel no link
« Reply #6 on: 2011-08-27, 00:40:35 »
Guy,
unfortunaly no play. I used Com1 inverted cable 2-3 but I didn't have succes. Tomorrow I will try Com2 straight cable.
With Daiwa rotor 4 motor Com1 all was ok.
73 Nicola