Remote Rig
Webswitch 1216H Support in English => Configuration, Webswitch 1216H => Topic started by: dk3pz on 2017-03-06, 15:02:24
-
From where I can get the value for the second configuration row = "e1" ; first row "48" is the CI-V adress of my IC706 used for automatic antenna selection
Function Type = '4'
ICOM CI-V/XK2000 Transc. Addr.(hex) = '48'
ICOM CI-V/XK2000 Contr. Addr.(hex) = 'e1'
73, Hans
-
Control Address is the webswitch adress used in the CI-V protocol. If you have more control eq like HRD, RS-BA1 etc on the same bus all need to have different addresses. If the WS is the only just keep e1
73 de mike
-
Thanks Mike,
using WS at the remote side for antenna selection and will fed the bus via CI-V Interface and RCC 1258 COM2 to the control side to use it with WSJT-X for frequency control
The program does not ask for any CI-V adress.... so I can keep it as you mentioned before
73, Hans
-
The program must have a CI-V address also, probably it's fixed if it's not changeable from the GUI. if it works keep it as it is
73 de mike