Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: DH8AAA on 2012-01-01, 15:49:00
-
Hello and a happy new year
I have a problem with my IC-R2500 firmware 2.20. and two MK2 FW.2.50.
The system works fine but....
After a few minutes turn off remote operation of R2500. The control unit also turns off but the RTP / UDP and audio status and
UDP cmd status remain connected. After a few minutes the R2500 and the control unit switches back on. This process is repeated again and again.
If I use program mode 9 (IC-E2820), I have other problems but not the on and off.
What can I do.
best regards
Oliver
DH8AAA
-
Many thanks to the development team and especially to Mike for the solution of my problem with the Icom IC-R2500 (on / off).
With the firmware 2.52, the problem seems solved.
A very good and fast support.
Best regards
Oliver
(DH8AAA)