Remote Rig
RRC 1258 Support in English => Hardware, Cabling, Installations => Topic started by: dg6ed on 2019-07-03, 15:47:25
-
High all,
I try to use my IC-E2820 with the RRC set below and with HM-133 adapter pcbs (both yellow and blue cables soldered as described).
- Radio: SNr.: 10556, Version 7, HW 8, SW 2.95, Bootloader 1.10
- Control: SNr.: 10496, Version 7, HW 8, SW 2.95, Bootloader 1.10
Everithing on RX side works fine, exept HM-133 functions don't work:
LEDs (red PTT, yellow Function etc.) get illuminated, when used accordingly, however no PTT, no remote control (e.g. change from VFO to Memory...) of the TRX is possible.
Any idea?
Thanks in advance,
-
This may be the solution
http://www.remoterig.com/wp/?page_id=2862 (http://www.remoterig.com/wp/?page_id=2862)
73 de mike
-
Hi Mike,
Visionairy power, great & thanks, works perfect!
I didn't mention, that the WLAN module might influence the overall funcionality - so I didn't mention, that there is one built in.
Recommendation: put this information in the manual of the 2820 section, where the HM-133 adapter is mentioned, once you do the next update.
+ + + Great product, great service, great solution + + +
Best regards,
Holger DG6ED