Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: K3TN on 2015-03-13, 11:39:01
-
I bought the "K3 Twin Stereo version" and have stereo cables on all audio connections in a K3/Mini to K3 Twin setup. The Control RRC label on the bottom has the S.
With the Dual RX setting OFF, if I turn the sub RX on I hear the audio mixed into both L and R audio channels.
When I turn the Dual RX setting ON, I hear the same thing - I do not hear the main in my left ear and the sub in my right ear.
Is there something else I need to do, other than changing that one setting?
73 John K3TN
-
There is only one setting in the RRC concering this and it's the "Dual-RX" switch, but the K3 has to be setup correct to produce separate speaker audio for the main and sub receiver.
73 de mike
-
Hi, Mike - bingo! Since I never had speakers connected when the K3 was local, I did not have the SPKRS setting to 2 for stereo. Turn that on in the CONFIG menu and dual RX works just like locally.
Thanks, John K3TN
Now, if I could just get the N1MM SSB PTT thing to work over RemoteRig...
-
Hi,
Need advise on settings. Recently purchased K3/0-Mini with cables. I believe I have old MKII.
Name Value
Company Microbit
Product 1258
PID 0
Version 4
HW 5
Software 2.90
Bootloader <= 1.7
Compiler 4.6.2
Build Feb 17 2016 10:16:14
ROM/RAM 481192/44080
ETH-RAM 2944 (max 3kB)
USB-RAM 15352 (max 16kB)
Battery-RAM 4
ResetSrc 0 [3]
Last WD Reset 2959316124
Uptime 0 Days, 0 Hours, 27 Mins, 17 Secs
I can't make MIX of Main and SUB channels in my Head Phones. My understanding that with Dual RX option I will have L-R channels on MAIN and SUB. But I hope that with current hardware I can do both receivers in both headphones mixed. Tried L-MIX-R setting in K3 AB-AB but still getting only MAIN receiver. What I am missing?
-
K3TN- John- What N1MM SSB PTT thing are you trying to do?
Dennis W1UE
-
Hi
Yes dual rx was introduced in version 5, if you have dual RX support a row with the text "Audio dual RX = Yes/No" shows up in the Radio-RRC.
Default settings is No to save bandwidth.
Yes if you have dual RX you can get the recievers separated, one to each ear
73 de mike
-
I understand this. Thank you!
My question if I can get audio from both channels mixed and delivered as mono? Currently I can't get SUB audio in any way. Can I achive it and what settings of K3 to check?
-
You set "SPKRS=1" in the K3 if you don't have a dual-channel RRC.
73,
Mitch DJ0QN / K7DX
-
Mitch! Thank you! You always help a lot.
At my case that was my fault. Didn't pay attention and I hade diversity active with no second antenna connected. Thank you for support! Just in case ordered newer interfaces.