Remote Rig
RRC 1258 Support in English => Configuration of Routers, Firewalls, etc => Topic started by: n0ac on 2016-01-19, 19:58:20
-
I'm just getting started with K3 to K3. When I turn on the control rig the remote doesn't power up. Should it? If the remote rig is powered up I can shut it down by powering down the control rig. If it can be powered up from the control rig where should I look to enable this function.
Bill, N0AC
-
Bill,
It can not be powered up using a CAT command. There is a cable in the kit available from Elecraft or Microbit
that plugs in between the RRC's rear I/O port and the K3's ACC port that allows you to turn on the K3.
73,
Mitch DJ0QN / K7DX