Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: LA7NO on 2015-10-21, 20:19:52
-
Hello list,
I have had my setup working nicely for a couple of days now. It is a standard configuration with IC-7100 radio on one RRC and the control unit on another RRC. The Radio-RRC is connnected to the router with Ethernet cable. The Control-RRC is connected to a 4G GSM mobile router (ice.net Smartrouter). I am using DynDNS and DHCP as described, and the router is setup with port-forwarding. So, the connection will be really remote, and not on the same local segment.
All works very well. However if I turn off power on the Control-RRC without first powering off the IC-7100 via the control panel, then things go wrong. Afer powering-up the Control-RRC again, nothing seems to works. It seems that the only solution is to reset the IC-7100 radio unit by powering it off and on.
Any clues anyone?
Regards,
Per-Tore
LA7NO
-
UPDATE:
Tried it again, but this time I've not been able to get it up and running again.
I can connect to both the Control-RRC and the Radio-RRC and look at status etc. All looks normal, except that the SIP status on the Control-RRC is "Unknown (1)". After resetting the Control-RRC, SIP status is again "Idle". But as soon as Ipress power-on on the IC-7100 panel, SIP status goes to "Unknown (1)" again.
P-T
-
UPDATE #2:
After several tries with full power off/on of everything, it is now up and running again.
Odd!
P-T
-
Could the cuse of these problems be reduced availability of the Remoterig DynDNS service?
I assume this is only beng used during initial setup of the connection. After that, it will work fine as long as a reset is not performed.
Anyone else experienced something similar?
P-T
-
Hi
I tested the same and it's no problem so I guess it related to your routers, not to the RRCs
73 de mike
-
Hi Guys it is my first post here.
I have same situation as described in this topic. It happens 4th time to me... I have RemoteRig from 6.2015 to now.
I had firmware v2.72, today I upgrade it to the newest. (By the way in old version I had sometimes this info: "Data Abort at 0x00046938, called by 0x00045f78". Some problems with memory leaking probably.)
On my local end I can see this:
Control panel OFF
Radio OFF
Connection status Disconnected
SIP status Unknown(1)
Last SIP error None
RTP/UDP audio status Disconnected
UDP cmd status Disconnected
And orange led blinks on RR.
It is not problem with IP/internet/router/ports forwarding. All needed ports are available and on my remote site I have public static IP. I made lot of QSOs already.
It seems that communication via RR can "hang radio" sometimes. For now I found only one solution... manualy turn off/on PSU connected to TRX.
I must find the way to turning Radio body without Control Head, I have connected IC-7100 to PC via USB and also via C-IV cable.
-
'SIP status Unknown(1)' could be more informative than saying 'unknown' as it is a timeout that has happened. It's the radio-RRC which considers the control-RRC being 'silent' too long as so makes a disconnect. But why it happens is another question...