Show Posts
1
General discussion forum / Re: DIGIMODES - RRC1258MkII - TS480SAT
« on: 2011-12-30, 14:03:51 »
How start the FSK on TX with RRC-1258 MKII and TS480SAT?
Using DX4WIN with MMTTY (both last versions). Tested with MMTY only - same result.
Other modes works fine, but not the FSK "diddle". Radio sends only the carrier, no FSK frequency change.
As described in the manual pages 76 - 81:
At Radio site: Wire jumper goes from I/O PIN 6 (Radio RRC OUT1 is set to Baudot/45) to the TS480SAT Remote connector PIN 7 - RTK.
Control site: MMTTY settings activated (COMFSK). The USB cable goes from USB PC (RRC COMFSK is set OK) to the USB on RRC.
All other modes (SSB, CW) works OK, but on FSK no "diddle".
Using last SW 2.50 on both RRC, Setup manager 1.12.
I canīt find, where is the problem. On the Radio site or Control site or the PC to Control connection?
Can I measure at an PIN on USB or RRC or COM port (which PIN nr?) with a scope where the signal is interrupted?
Who can help?
I lost many hours to find a solution - no succes.
73, HNY
Milan, OK7GU
Using DX4WIN with MMTTY (both last versions). Tested with MMTY only - same result.
Other modes works fine, but not the FSK "diddle". Radio sends only the carrier, no FSK frequency change.
As described in the manual pages 76 - 81:
At Radio site: Wire jumper goes from I/O PIN 6 (Radio RRC OUT1 is set to Baudot/45) to the TS480SAT Remote connector PIN 7 - RTK.
Control site: MMTTY settings activated (COMFSK). The USB cable goes from USB PC (RRC COMFSK is set OK) to the USB on RRC.
All other modes (SSB, CW) works OK, but on FSK no "diddle".
Using last SW 2.50 on both RRC, Setup manager 1.12.
I canīt find, where is the problem. On the Radio site or Control site or the PC to Control connection?
Can I measure at an PIN on USB or RRC or COM port (which PIN nr?) with a scope where the signal is interrupted?
Who can help?
I lost many hours to find a solution - no succes.
73, HNY
Milan, OK7GU