Remote Rig
Webswitch 1216H Support in English => Configuration, Webswitch 1216H => Topic started by: DL2MIJ on 2016-09-20, 21:49:12
-
Hello , i need assistance with my 1216H Webswitch.
I like to remote my Yaesu G-2800DXA Rotor with an WS + 1216S cable.
1st of all , is additional hardware necessary ( a serial connecting cable Rotor to 1216S is here.. ) , the Rotor with a mini din serial port ?
And , when i push the 1216S in the WS , the greene LED going out and i can`t find the WS in net. WS config is no problem , but no more with the 1216S ?
Pin 1 ( red ) is on Pin 1..
Thanks for you help.
Bob - DL2MIJ
-
As far as I now you always need the "GS-232B Rotor Controller Interface" to get a serial port connection to the Yaesu Rotators
73 de mike
-
TNX for your replay Mike and SRI for my late response !
YES i understand now , the output is not serial from the Yaesu Rotor , i had now a RotorCard.
But one question please : I don`t no, is possible the 1216S is damaged by my own fault , i put him 1st time wrong in the WS ? Now is the WS out ( the smal greene light going out and i find him no more in my network) when i plug the 1216S in the right position.. Without the 1216S i had no problem to config the WS.
vy73 Bob
-
I have never got a broken 1216S back but probably it's posible to damage them. If the webswitch stops working when you connect the 1216S it's looks like it's broken .
/mike
-
Mike thanks !
i will look for an new on and test again..
vy73 Bob