Remote Rig

RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: bill_KE5XV on 2021-03-23, 18:21:10

Title: IC-7100 JMP-2 conflicting information in manual
Post by: bill_KE5XV on 2021-03-23, 18:21:10

There are two statements in the manual that are in conflict. This is for the Control box.

Page 23 the manual says -- JMP-2 is used to select if the DC-power to the front panels should be 8 or 9 V. With the strap in place it will be 8V, which fits all ICOM radios.

On page 108 for the IC-7100 the jumper table shows a '0' (not installed) for this radio.

Which of these is correct?

Thanks and 73, Bill, KE5XV

Title: Re: IC-7100 JMP-2 conflicting information in manual
Post by: sm2o on 2021-03-24, 14:51:16

Both is OK as the voltage is regulated inside anyway, but leave the jumper there to get 8V.

added:

I checked the manual and it says it should be there, it's on page 109 I guess you have a old manual

73 de mike