Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: kg9n on 2012-07-19, 19:32:39

Title: rrc micro pc client with ic7000
Post by: kg9n on 2012-07-19, 19:32:39

Has anyone used an rrc micro pc client with an icom 7000? If so what all do need make make it work? Thanks, Chuck KG9N

Title: Re: rrc micro pc client with ic7000
Post by: KP4TR on 2012-07-22, 06:55:50

It is doable, even though I have not owned one, but I do have micro PC client that I have used with Kenwood.

Without going into specifics, all you need is an ICOM serial cable between the RRC radio COM2 and the IC 7000 CI-V port on the radio. And configure the micro client for Icom CI-V with appropriate COM2 port and address. On your end load software on PC to manage IC-7000 remotely and configure ICOM CI-V on micro client as well. You will be using the virtual port on the PC configured to use with micro client.

Title: Re: rrc micro pc client with ic7000
Post by: KP4TR on 2012-07-22, 07:21:55

Forgot, also microphone wiring per manual for Icom, and speaker cable. TTL panel connector is unused.

Title: Re: rrc micro pc client with ic7000
Post by: Jeff G3LWM on 2018-04-10, 21:55:06

Hi

Do you know anyone using an IC7000

Thanks

Jeff G3LWM