RRC 1258 Support in English > Configuration, RRC 1258

Icom 7100 CIV control

(1/2) > >>

VK3OE:
Hello,

I have acquired an IC-7100 and wish to use the control head ( which is on COM 0 ) and the CIV from the remote unit at the same time so that I can use HRD or any similar logging program to get the frequencies and modes of the remote unit into the computer. I have tried to configure this arrangement but the CIV backhaul that I use with the IC-7000 is precluded as it requires to place COM2 logically in parrell with COM0 at the control which is in conflict with the IC 7100 configuration.

Ideas please??

Andrew
VK3OE/VK3OER

sm2o:
Hi

Set com2 to mode 2 in both RRC:s.

73 de mike

EA1AF:
Hello,

I have a problem also with the CI-V and IC-7100.

I have selected Mode 2 in both RRCīs in COM2.
I use a straight RS232 cable from Control to RRC and a TTL converter from the rear part or the radio (remote) to RRC.

The cable is working OK, tested without the remote system.

I tried all the baudrate speeds and configurations in the mode 2 of COM2.

I donīt know where is the problem. ŋ Any ideas to test?

Thanks in advance.

EA1AF - David

sm2o:
What control software do you use ?

/mike

EA1AF:
Logger32 here.

EA1AF - David

Navigation

[0] Message Index

[#] Next page