Remote Rig

RRC 1258 Support in English => Configuration of Routers, Firewalls, etc => Topic started by: n6xi on 2013-09-07, 06:13:22

Title: Have to restart Control RRC after each power-off
Post by: n6xi on 2013-09-07, 06:13:22

Running a K3 Twin setup with thanks to SM2O and DJ0QN for a lot of help. It's working well now but I'm curious why I have to Restart the Control RRC manually each time I power off the rigs. Without that Restart, the units fail to connect ("busy signal").

I have noticed that when the RRCs are connected, the Control RRC Status page reports unusual port numbers for SIP Out, Audio Out and Cmd Out. After power off, the funny numbers persist but after the RRC Restart they are restored to the nominal values and reconnect works fine on the next power on. Is this normal or somehow related to why I have to do the manual Restart?

/Rick N6XI

Title: Re: Have to restart Control RRC after each power-off
Post by: sm2o on 2013-09-07, 09:06:37

Hi

I have never heard anyone having to restart every time before connecting. The change of portnumber you see is normal, it's a result of the router doing portmapping, The RRC do not change portnumber, but  adapt to the routers mapping. As you had router problems before also I should have tested with another router. Use one from the big brands Linksys, Netgear or D-link they always work.

73 de mke

Title: Re: Have to restart Control RRC after each power-off
Post by: dj0qn on 2013-09-07, 12:26:11

Hi Rick,

I agree with Mike, it looks like a router problem to me.

73,
Mitch DJ0QN / K7DX