Remote Rig
RRC-Micro PC Client in English => General discussion => Topic started by: KM2O on 2011-06-10, 23:27:23
-
Hi,
I have upgraded to the latest (64 bit) RRC micro client. Following this Ham Radio Deluxe stopped working. I notice that there are now 3 additional microbit com ports (6,7 & 8). HRD used to work fine using the COM 3 and now gives an error message. It does not like any of the microbit com ports. The RRC micro connects fine to the radio but there us no control using HRD. Thanks for any help.
73
Dave KM2O
-
You should use the new Com-ports named "Microbit RRC" and the Control Software selection "Hamradio Deluxe".
Also you need the firmware version 2.37 or later. The latest version is recommended.
-
As always, thanks Roland!
Got it working again. Now looking forward to implementing the CW send.
73
David KM2O