Messages

16

General discussion / Re: RRC micro changes

« on: 2017-11-18, 22:28:49 »

Thanks
73
Neil
VE6TCK

17

General discussion / Re: RRC micro changes

« on: 2017-11-18, 21:58:17 »

Thanks for the check list Mitch that will be helpful  to many I did read the manual but my comprehension may have been lacking ( I suffer from a diagnosed learning disability and am old enough to remember 8" floppies hihi)  I try to stay abreast of technology but it might be winning. I will keep at it ...but back to the question I posed. Will my local rig control software in this case ARCP480 communicate and control the RRC1285MKII on the remote site with out a computer on that site? I am lead to believe this from the graphic on the RRC micro PC Client page. My  RRC Micro will be here Monday and I will be back at it in earnest.

TKS
73
Neil
VE6TCK

18

General discussion / Re: RRC micro changes

« on: 2017-11-18, 05:10:31 »

Thanks Mitch I got the cable installed I am starting to work with Kenwoods ARCP480 for control but I am not able to connect, am I correct in assuming that this software will connect directly to the RRC 1258 MKII with no CPU on site ? I suspect I have an issue with port forwarding or some other such thing .....I realize this is not "kenwood "support but what info you can provide would be helpful.

Thanks
Neil
VE6TCK

19

General discussion / RRC micro changes

« on: 2017-11-17, 02:45:17 »

I have ordered the RRC MICRO but it is a week away and I will be visiting my remote site (300 KM trip one way tomorrow) I presently am using a TS480  and RRC1258MKII's which work great. Do I need to make changes at the remote site to allow use of the RRC MICRO?
Tks
Neil
VE6TCK