Show Posts
1
General discussion forum / Re: Setting up Icoms software RS-BA1
« on: 2012-12-14, 00:15:36 »
Have the same setup: 7600 and RS-BA1. RRC boxes connected and RS-BA1 is talking to the radio via USB COMM0 port.
Can put the 7600 in xmit but no tx audio is passed. I can then switch to HRD to control the radio and in the xmit mode
tx audio is present and passed. Currently I am setup on LAN not remote. Any thoughts? I really would prefer to use the
RS-BA1 software control and my RC-28 instead of HRD.
Thanks,
Robie K9RDW
Can put the 7600 in xmit but no tx audio is passed. I can then switch to HRD to control the radio and in the xmit mode
tx audio is present and passed. Currently I am setup on LAN not remote. Any thoughts? I really would prefer to use the
RS-BA1 software control and my RC-28 instead of HRD.
Thanks,
Robie K9RDW