Remote Rig

RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: G3UKB on 2016-03-21, 20:28:23

Title: 7100 Data Modes
Post by: G3UKB on 2016-03-21, 20:28:23

Hi,
Is there a way to transmit using JT65-HF on the IC7100. I can obviously receive via the audio out jack on the head end but the data connectors are on the radio side. I have remote CAT control set up so can probably get PTT to work but short of messing with the mic connector I can't see a way to get audio in.

Bob

Title: Re: 7100 Data Modes
Post by: sm2o on 2016-03-22, 09:33:12

Hi

I do not now much about JT-65 but isn't it possible to use the mic audio path in the Remoterig system in the same way as for PSK-31 ?

73 de mike

Title: Re: 7100 Data Modes
Post by: G3UKB on 2016-03-22, 10:07:45

Thanks for the hint. Actually I've not used any data modes with remoterig so yes the same method should work. Could you explain how to use the mic audio path. I can't find any reference in the documentation to that.

73 Bob

Title: Re: 7100 Data Modes
Post by: sm2o on 2016-03-22, 10:20:07

Hi

With the IC-7100 you connect to the mic input of the IC-7100 frontpanel,Where the mic is normally connected. See IC-7100 manual about how it's configured. Below is a link to how it can be done with the IC-706, it's almost the same situation

http://www.remoterig.com/wp/?page_id=444 (http://www.remoterig.com/wp/?page_id=444)

73 de mike

Title: Re: 7100 Data Modes
Post by: G3UKB on 2016-03-22, 11:08:04

Thanks.

73 Bob