1
General discussion forum / USB0 disconnects. Requires RRC reboot to recover
« on: 2011-10-13, 07:04:09 »
Within a minute or so of using USB0 on the Control RRC to control the remote 746pro, the rig software gets disconnected from the remote radio. The Control RRC then needs to be restarted to reconnect to the radio again. (the audio stream is fine all the time)
The same setup works fine when I move from the USB0 to COM2.
The error log and the config files are attached.
Regards,
RX3DUX / NS6W
The same setup works fine when I move from the USB0 to COM2.
The error log and the config files are attached.
Regards,
RX3DUX / NS6W