RRC-Micro PC Client in English > General discussion

RRC-Micro with HRD and FT-897

(1/2) > >>

SM0SHG:
Hello,

Trying to get the combination RRC-Micro, HRD and FT-897 to work.

I have audio and I can transmit using the PTT button on the RRC-Micro "dongle". No problem. But I can't reach the FT-897 with HRD. Please see the attached pictures for my settings.
I'm using the CT-62 cable between FT-897 and COM2 on the RRC-1258 box. The FT-897 is "tuned" to 9600bps under menu 19, and meny 20 says "CAT".

What am I doing wrong?

Best Regards,

Adde

roland:
You need to define settings for COM2

SM0SHG:
Hi Roland, and thanks for the answer.

I have tried this also, but it does not work. I read in the FT-897 manual that the CAT interface uses 2 stop bits. I have tried both 1 and 2 stop bits, but still get the msg that HRD is unable to connect and read the frq.

(The CT-62 cable works fine when I connect it directly between FT-897 and computer)

Any other suggestions?

Adde

roland:
Did you set 2 stopbits at COm3 stop bits also?

SM0SHG:
COM3?! Was that post correct?

Navigation

[0] Message Index

[#] Next page