Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: OH3YG on 2014-11-23, 16:21:11
-
Hej,
I have a problem with my AS1268. When I running on low power (20w rf) it works and I can select relays what I want but when I put more power, also another ralays go on same time?
Have someone (Mikael Styrefors) any idea for repair it.
73
Harri
OH3YG
-
Looks very strange. The relay are controlled direct from the CPU via a Transistor, so there is nothing to repair. Is this happen when you use manual control or automatic ? Do the web GUI indicate that more than one relay is active ? What firmware version are you using ?
73 de mike
-
Thanks Mike for the fast reply. It is AS-1289 and the firmware 2014-04-02. I have used it manual control. The web GUI indicate that one relay is active but the leds of relays in the box are lighting and the relays go on.
If I use over 100w power so every relays and leds go on???
I have checked a voltage on the relays transistor gate and the voltage (3-4v) was the one transistor only, ok. But....?
73
Harri
oh3yg
-
Harri,
Check my posting -- AS-1289 RF noise heard on receiver --
Perhaps the grounding will help your AS-1289 TX problem also.
73
Pete
-
Hi Pete, I will check your post. Thank you
73
Harri
-
Sorry Pete, it didnt help me. QSX
73
Harri
-
Hi
You did not say if it has been so all the time or if has happen after some time ? I saw you have bought it 6 month ago. I guess you have to send it to us for repair, there is nothing which can be repaired other than replacing the whole control board
73 Mike
-
Hi Mike,
It has happen when I checked my linear amplifier on this autumn.
I use a band decoder on this moment, so no need to repair.
73
Harri
ps. of course you can send the control board for me if you want hi..