Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: ur5mid on 2013-09-05, 19:15:04
-
K3/0 working is well without computer. Any logger do not find com-ports. I tried via virtual port or to direct COM1.But no results.
PS: COM1 ( COM4)
COM2 ( COM7)
control panel serial number 2511
radio control serial number 2600
software 2.72
Serial settingsCOM1 mode 3
COM1 baudrate 1200
COM1 data bits 8
COM1 stop bits 1
COM1 parity off
COM1 rts/cts yes
COM1 terminator (hex)
Use USB Com Port as COM1 yes
COM2 mode logical parallel with com0
COM2 baudrate 9600
COM2 data bits 8
COM2 stop bits 1
COM2 parity off
COM2 terminator (hex) o
Use USB Com Port as COM2 no
COM3 mode (USB-COMFSK)
Radio settings 14
Sip password
Sip contact
Auto connect No
Audio quality 2
Codec out gain 255
Codec inp gain 18
Codec inp HPF Hz 327
Codec inp preamp yes
COM0 baudrate 9600
COM0 data bits 2
COM0 stop bits off
COM0 parity 2
COM0 Program mode 3 char timeout
Use USB Com Port as COM0 no
-
I assume that you are using the K3 Twin mode, since you didn't make that clear.
If so, here is how you get CAT working:
- Go to the serial settings on the radio RRC and change COM1 to "Mode-7, CAT to COM2". Make the rate the same as COM2.
- Go to the serial settings on the control RRC and do exactly the same
- While on that page, change "Use USB COM port to USB" to YES if you want to use the virtual serial port, otherwise connect
a serial cable to COM1 on the control RRC (but watch out - the pinout is backwards from normal!)
73,
Mitch DJ0QN / K7DX
-
I will try to install tomorrow.
But i want using COM1 for rotator.
COM0, COM1,COM 2 only for CAT???
it`s stangely
-
That is unfortunately how it is. On a normal RemoteRig configuration, you would use
COM2 for CAT and COM1 for something else, such as the rotor.
However, the "Twin" configuration (Elecraft & Yaesu) use COM2 to communicate
between the two RRC's and therefore block this port. So the only way to get CAT
on the remote end is to use a mode that combines COM1 and COM2 and use
COM1 for CAT.
You will therefore have to find another solution for your rotor, such as a serial
server or Webswitch.
73,
Mitch DJ0QN / K7DX
-
I installed COM1 to mode 7. it`s work very well.
But i have new problem. After 15 minutes, the connect disappeared. The control panel shows the message "IP error." I do not know why. Installation did not change, except for COM1.
-
:) now ok