Remote Rig
RRC 1258 Support in English => Configuration, RRC 1258 => Topic started by: MW0NRE on 2021-01-24, 20:23:53
-
Just doing the initial setup and thought I'd check that the remoterigs were connecting but I'm seeing Disconnected, is this expected with no radio gear attached, or have I done something wrong?
Niamh
-
Niamh,
Mike may wish to confirm, but I am very sure that it can not connect without a rig.
73,
Mitch DJ0QN / K7DX
-
Thanks Mitch, I was trying to proceed in small steps checking each stage.
Niamh
-
Hi
both files are from the control-rrc
in ft-857 mode it will not work without a radio as PWR-ing on the frontpanel is initiating the connection
modes where there is a connect button on the status page will work without a radio
73 de mike
-
That'll teach me to rush! Correct radio config attached.
Will try a different mode to test that the remoterigs are communicating
Niamh