RRC 1258 Support in English > Configuration, RRC 1258

bootloader update

<< < (2/3) > >>

EC5AN:
Gracias Mike

El problema que tengo es.

Cuando actualizo las dos unidades de RRC1258 al 2,72 no funciona.

Tengo que dejar la versión 2.62 en la unidad de radio para que funcione. De esta forma funciona perfectamente. Pero no debe ser correcto.

Lo único que se queda diferente es el bootloader que en la unidad de control es la 1.10 y la unidad de radio 1.9

A ver si tengo suerte y alguien me responde.

73s
EC5AN
JUANMA

EA7EU:
Mike, Juanma means:


He wanna control a Icom  2820.
At Radio RRC  runs the firmware 2.72 and the bootloader 1.09.
At Control RRC runs the firmware version 2.72 and the bootloader 1.10

With these configuration it doesnt work !!!

He thinks that if he changes the bootloader to the same version should work, isnt it?

The same version should be on both RRC tu run properly.

How can he change the bootloader version?

Thanks

sm2o:
The bootloader has nothing to do with the function when the unit has booted up. We have so far never sent out a new bootloader so the problem he has is depending on something else. Probably cabling or setup.

73 de mike

EA7EU:
OK MIke.

Thanks.

EC5AN:
rrc1258 radio version 2.62 ok
rrc1258 radio version 2.72 not ok

idem config

what problem posible?

Navigation

[0] Message Index

[#] Next page

[*] Previous page