Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: w7fz on 2011-03-16, 23:22:15
-
On a recent business trip I took the Control RCC and the TS480 Control Panel with me. I operated as often as I could in view of my busy schedule. Upon returning home I upgraded the FirmWare to FW2.34. About two weeks after that I wanted to demonstrate the RCC system to my son who was spending the weekend home from university. I could not get the system to respond. I thought that, perhaps, the FW upgrade had been corrupted so I re-installed FW 2.33. The system still did not work. I have tried everything in my limited knowledge, including checking the cables. In desperation I am attaching tables containing the status of the Radio RCC as well as the Control RCC, all connected with the TS480 within my LAN. I did not change any parameters after my business trip. Is there a way to connect the Radio and Control RCC's together to see if they will provide connectivity? I need help. I have another business trip coming up.
w7fz
Robert
-
Hi
remember that when you use them in the same LAN at home you must change the SIP-contact in the Control-RRC
73 de mike
-
Also it's a good idea to check the Status page just after attempting to connect. Doing so show the most current status regarding the connect attempt.
For ex:
Last SIP error SIP Error
could be shown in the Control RRC if the SIP connection to the Radio RRC fails, for ex. due to wrong SIP Contact.
-
Hi Mike and Jan
I am very grateful for two very astute amateur radio operators. Your advice solved the problem. I had completely overlooked to change the SIP Contact. I was tearing my hair out trying to solve the problem, and at my age I don't have much more hair to tear out. Thanks a million.
73
w7fz Robert