Show Posts
1
Configuration, RRC 1258 / Icom IC-7100 CW not working
« on: 2014-06-05, 16:14:27 »
Hi,
Running a Icom IC-7100 remotely.
Cannot get the radio to key up in CW mode.
I have sidetone on Control side.
When I pull the cable on Radio side, there is life - so using a key directly to the radio works.
Seems like CW is not generated out of PAD port to the Radio.
At control side I both use a bencher via Pad port and N1MM to generate CW via I/O port.
Both does not key up the radio.
Per manual menu in radio is set to straight key.
Using internal Memory Keyer in radio does send CW.
This solution worked 100% in an TS-480s environment.
I just re-strapped and used the same cable for CW-keying at Radio side for IC-7100 usage
Everything else works like a dream - also CW-keying via control-head. But. latency will some time make it difficult.
What am I missing here?
Per
la7dha
Running a Icom IC-7100 remotely.
Cannot get the radio to key up in CW mode.
I have sidetone on Control side.
When I pull the cable on Radio side, there is life - so using a key directly to the radio works.
Seems like CW is not generated out of PAD port to the Radio.
At control side I both use a bencher via Pad port and N1MM to generate CW via I/O port.
Both does not key up the radio.
Per manual menu in radio is set to straight key.
Using internal Memory Keyer in radio does send CW.
This solution worked 100% in an TS-480s environment.
I just re-strapped and used the same cable for CW-keying at Radio side for IC-7100 usage
Everything else works like a dream - also CW-keying via control-head. But. latency will some time make it difficult.
What am I missing here?
Per
la7dha