« previous next »
Pages: [1]

Author Topic: Kenwood radio (ts-590) connected to a SW 1289  (Read 206 times)

ea3in

  • Jr. Member
  • **
  • Posts: 82
    • View Profile
    • Email
Kenwood radio (ts-590) connected to a SW 1289
« on: 2024-05-04, 01:50:26 »
Hello

Can the P1 connector be directly soldered to a Serial 9pin connector to control the switch from a Kenwood transceiver serial port?

73s de Marcel
Logged

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3012
    • View Profile
    • sm2oan
    • Email
Re: Kenwood radio (ts-590) connected to a SW 1289
« Reply #1 on: 2024-05-04, 07:27:29 »
No. You need a 1216R or 1216S cable the have a RS232 interface in the dsub. It can of course be made DIY.  73 de mike
Logged

ea3in

  • Jr. Member
  • **
  • Posts: 82
    • View Profile
    • Email
Re: Kenwood radio (ts-590) connected to a SW 1289
« Reply #2 on: 2024-05-04, 10:55:48 »
I think a 1216S unit is in stock at a local distributor

I guess I can use a 1216S or 1216R. Just changing the TX/RX cables 

Is the P1 connector NOT RS-232 level?
Logged

sm2o

  • Administrator
  • Hero Member
  • *****
  • Posts: 3012
    • View Profile
    • sm2oan
    • Email
Re: Kenwood radio (ts-590) connected to a SW 1289
« Reply #3 on: 2024-05-04, 14:23:12 »
P1 is 0-3V levels not RS232.

1216S and 1216R is the same but different gender. and 2,3 shifted  so both can be used by adapting the cable to the radio

73 de mike

Logged

ea3in

  • Jr. Member
  • **
  • Posts: 82
    • View Profile
    • Email
Re: Kenwood radio (ts-590) connected to a SW 1289
« Reply #4 on: 2024-05-04, 17:28:09 »
Clear!

Logged
Pages: [1]
« previous next »