RRC 1258 Support in English > Configuration, RRC 1258

K3/0 mini - K3S Twin setup Term on K3/0

<< < (2/3) > >>

WC2L:
Call it a brain fart on my side or post and end up with an egg in my face...
Station reconfiguration and that cable not in the pile will get you every time!!

FYI, I am in Canada listening to my station (I will get on). I have the AP client working!
Thanks for all of your GREAT support!!

Will WC2L

cx6vm:
HELLO!!

I did a search about this problem.

I was using two K3/100 and never happened to me to see that the TERM does not go away and the remote K3 display does not show

10 days ago I got a K3/0 Mini with factory cable RRMINICBL and I started often to see that the TERM does not go away and the remote K3 display does not show

So the problem may be is a bad RRMINICBL  cable?

thanks!
Jorge
CX6VM/CW5W

dj0qn:
Did you change the new mini to the correct RS232 baud rate?

73,
Mitch DJ0QN / K7DX

cx6vm:
yes Mitch

remote radio and control radio (K3/0 Mini) are in 38400

73,
Jorge

dj0qn:
Hi Jorge,

OK, because that is usually what causes this type of problem after switching. Otherwise, they should work
identically using the old RRC.

I suggest contacting Elecraft support, since this is their product.

73,
Mitch DJ0QN / K7DX

Navigation

[0] Message Index

[#] Next page

[*] Previous page