Remote Rig

RRC 1258 Support på Svenska => Allmänt diskussionsforum => Topic started by: oz8so on 2010-11-08, 22:49:45

Title: FT-817 & RRC Client + HRD
Post by: oz8so on 2010-11-08, 22:49:45

Hello helpers...

I have problems connecting HRD via RRC client to FT-817.

HRD can not find the COM port

The client program is in contact with RRC
FT-817 is connected to RRC COM2 with CT-62 cable

Mode 3 "FT-8x7" can not be selected in the client program?

In RRC - Do I need to select COM2 in parallel with COM0? or when is this option used?

Any suggestions to stopbit and terminator?

Or what have I completely missed???

73
Jens/OZ8SO

Title: Re: FT-817 & RRC Client + HRD
Post by: sm2o on 2010-11-11, 09:35:43

Hi

Mode "3 - char timeout" is the same as mode 3 - FT-8x7..... in the RRC.

you should activate com 2 in the RRC (not in parallel with com 0).

as far as I remember FT-817 uses  8 data bits and 2 stop bits and 4800 baud check the manual of the radio.
there is no terminator needed in mode 3.

73 de mike