Remote Rig

RRC 1258 Support in English => General discussion forum => Topic started by: N9CEV on 2011-08-07, 15:55:47

Title: IC Socket Orientation
Post by: N9CEV on 2011-08-07, 15:55:47

Yesterday I began configuring my Remote Rig. 

My concern is that the covers are off the Control and Radio units and I'm looking at them from the front. The pin-1 indicator on the Control unit IC socket is at the right and the pin-1 indicator of the Radio unit IC socket is at the left.

Is this correct or was there a manufacturing error?

I'm probably over-thinking this, but I hate smoke.

I tried to post this yesterday, but it doesn't seem to have shown up.  If it shows up twice, I apologize for the bandwidth.

Thanks in advance