Remote Rig
RRC 1258 Support in English => General discussion forum => Topic started by: IZ0JOJ on 2022-07-23, 14:28:33
-
Hello to everyone (Hello Mitch!)
I am using my Remote Rig setup with my Kenwood TS 480 which works perfectly fine and stable between my shack in Milan, Italy and Crotone, Calabria.
I stopped my ham radio activity since two months. I moved to another apartment. Today I wanted to do some ham radio: I turned on my radio, I get full display but no RX audio. NEITHER the BEEP of the radio when you change band or you tune the antenna! I can use the dial, I can trasmit, I can tune...
no RX audio!
I did the reboot at both ends (interfaces) and both routers (internet). No change.
Any idea?
73 Antonio IZ2JOJ
-
I got an update!
Now I don't get neither display of the frequency - panel does not turn on. Only the yellow led is on (interface).
P5.4 ON
Radio ON
Connection status OK
SIP status Connected/transfering
Last SIP error None
RTP status Excellent(60)
UDP cmd status OK(33)
SIP command timeout 0
Rx Jitter buffer size 4
Rx Jitter delay 3
Dual Rx 0
Current audio packet size 20
Current audio quality 2 - Linear 16 bits 8 kHz
SIP Out port 13005
SIP In port 13005
Audio Out port 13001
Audio In port 13001
Command Out port 13002
Command In port 13002
External SIP In port 13005
External Audio In port 13001
External Cmd In port 13002
Other party 93.51.96.88
Input 0 High
Input 1 High
Input 2 High
Output 0 High
Output 1 Low
Output 2 Low
DNS status OK, t05lcmmo.ddns.remoterig.com = 93.51.96.88
Active profile Default
PTT status OFF
Common network settings Yes
Thank you
-
Can someone help?
Thank you
-
The status shows that no data is transferred. Can be many reasons for that. cables, settings, routers etc. I suggest you take all items to the same place and check that it works on LAN without Internet, and start from there
73 de mike