RRC 1258 Support in English > Configuration, RRC 1258

Using the USB or COM1 port on Radio RRC for CAT control by FT8 software

<< < (2/2)

w3hzz:
I am a complete novice at this, so forgive this basic question.

I am running a K3 and K3/0-mini in twin mode. At the remote station, I have an antenna switch, AS-1289, connected to the RR through the D-sub. As I understand it, I have no other serial ports available for CAT control of the K3 from the remote position. Is there a workaround that will allow me to run both the AS-1289 and CAT control of the K3 at my remote station. I am mostly at the remote location, so CAT is needed. (I am able to get CAT control of the station from the control position using a USB, mode-7.


Phil, W3HZZ

dj0qn:
Phil,

The AS-1289 does not connect to the RRC using a serial port. It uses a network interface over IP instead. The RRC's COM1
should be available for CAT usage.

73,
Mitch DJ0QN / K7DX

Navigation

[0] Message Index

[*] Previous page