Remote Rig
Webswitch 1216H Support in English => General discussion forum => Topic started by: sv5byr on 2013-01-08, 19:45:12
-
Hello and Happy New Year to all,
So far I using my TS-2000 on voice only. Trying to setup the CW operation on remote I realize that my radio is not keying at all...
I have test on remote site the straight key input and works fine with my straight key and also with a homemade COM port keyer (with 4N25). Connecting the key output from the box to Radio and trying from my Base nothing is happened. I make all combinations on 3,5 mm stereo plug but nothing... I make also all combinations on software but nothing.
Any Advice pse???
-
Did you enable the keyer using with the RRC web config pages? If not, please refer to
page 84 of the manual for details.
73,
Mitch DJ0QN / K7DX
-
Yes all this done....
But nothing
-
Send me your keyer and I/O settings for both RRC's, there must be something wrong.
My direct e-mail is dj0qn (at) darc.de.
73,
Mitch DJ0QN / K7DX
-
tnx for response Mitch,
was the I/O on radio side. Now all ok...
Sri for trouble. Happy New Year.
SV5BYR
Mike