Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.


Messages - chris g3yhf

Pages: [1]
1
I'm now getting error code 19 on dynamic DNS, although my remoterig setup has been working perfectly for several years and i havent made any changes.
i updated firmware to see if this would solve problem, but it hasnt.
So i'm unable to connect remotely.
i can see my status is ok at the DDNS status page.
Thanks for any assistance!

2
Configuration, RRC 1258 / Re: no rx audio RTP/UTP stalled
« on: 2017-02-27, 19:40:45 »
Thanks Mitch - yes i've done all that and just redid to double check, and also looked at all the router functions to see if i can spot anything!  i have this problem when using both boxes on my LAN.  i will see if one of more tech-savvy members at my local club can take a look!  chris g3yhf   

3
Configuration, RRC 1258 / no rx audio RTP/UTP stalled
« on: 2017-02-26, 17:15:18 »
This is new RRC1258 - when first setting up the RRCs at home everything worked 100% and also on my first remote operation.  But on returning home I have an intermittent problem. 

When switching on IC7100, using home LAN, everything is 100%.  But often if I switch off 7100 (leaving RRCs on) and then switch on again within a few minutes the 7100 control head comes to life, all features work but there is no RX audio.  Then 7100 switches off and on again automatically every 30 seconds, but the RX audio doesn't come back on.  Switching off RRCs and then switching back on again doesnt solve problem.  problem occurs whether using wifi or ethernet for control RRC.

However if I switch everything off for maybe an hour, i can switch back on and it works 100%. 

When this problem occurs radio RRC status shows everything is OK and i can hear audio on Radio RRC.  Control RRC status shows RTP/UTP audio stalled, but UDP cmd OK.  so i think switching rig off and then back on stops audio being streamed from Radio RRC.  All RRC settings are defaults (e.g. ping watchdog not enabled). 

Seems like some sort of timing issue caused by switching rig off and then on??  Any assistance welcome - I can see similar problems on Forum, but no solution to my difficulty!!

Really like Remoterig - excellent product and enables me to get on air from my alternate QTH (apartment with no possibilities of antennas!)

Chris G3YHF



Pages: [1]